BATIGE USB 3.0 & 3.5mm Car Mount Flush Cable, 3ft

I installed this in the center console where my parking brake is for an Acura RSX. Make certain that your USB plug or a USB stick will clear your parking brake lever when it is in the down position.Look SUPER clean and professional.1) - For those who drive an ACURA RSX, I had to put this in the center console because there was NOWHERE for me to install in my dashboard. There just was not enough clearance for it to fit without it knocking into something.2) - I also DID NOT want to lose my cigarette lighter because that is where I keep my Fast Charge USB which has 2-USB-ports for my other devices.I highly recommend you ALWAYS " dry-fit" this first. The installers did not, so they had to buy me a new car piece.===========1) - This WILL fast charge your phone, as long as you are plugging in a fast-charge cable to it.2) - The AUX works great too.3) - I am using "JetAudio", "Pulsar" and "Rocket Player" apps so that I can listen to my MP3 music simultaneously while on Google Maps.

Excellent build quality, good, long cords, works perfectly with my Alpine in-dash Nav. It easily mounted in my dash (I drilled a 1" hole to fit it). Highly recommended.

I installed an aftermarket radio in my daughters car. I did not want wires hanging out of the dash looking all sloppy. I purchased this and drilled a hole to mount it in the under portion of the dash. This has a very sturdy USB port and 3.5 mm audio jack for aux input. I was able to securely mount this and route the wires behind the dash for a clean install. This has well shielded heavy cables to connect to the back of your radio.

Car play

My 2010 Chevy Silverado came with two cigarette lighter ports. Actually one was just a 12 volt port to plug up chargers etc. Anyway I didn't need the cigarette lighter port. When I bought the truck used the former owner had installed an aftermarket radio. It has a USB port on the back so you can use radio screen with Android Auto gps. He had a USB cable plugged into the radio and the cable laying on the tranny hump in the floor with a female end on it. He would plug a short USB cable to that to use Android Auto. I wanted it to look cleaner and decided to do it this way. I installed this where the cigarette lighter port was.As a side note, I had to make the old hole in the dash trim a little bigger. This new USB port needs a 1 1/8" hole and the hole in my dash trim was just a hair over 1". No big thing. Use a round file or rasp to enlarge the hole. Only takes a few minutes.

Works great, looks great. Charged my phone quick and easy to install depending on your application.

Most new touchscreen stereos have their AUX Input and USB Input jacks on the backside, requiring extension cables. If you aren't a smoker, then why not use that cigarette lighter jack instead of those extension cables that'll just sit on the floor? This looks "factory."This particular unit works great in a 2005 Toyota Sienna, which has two cigarette lighter jacks. In my particular car, I needed to file away a little plastic on the console to widen the hole so that this extension fit properly. I'm not sure if Toyota has slightly narrower holes, or someone at the Batige factory didn't quite measure something perfectly, but after a minute with a rounded file (my Dremmel's battery was dead), it fit right in. Highly recommended.

The USB connector head is a little too thick for easy installation in the dash behind my Pioneer NEX5200. I imagine with as thick as the cable is and being USB3.0, it will be excellent for not losing power over the cable length. I took it to a car stereo installer and he was able to clear out enough space behind radio to make it fit (there's a lot of wires back there with the interface for steering wheel controls). So it's working great, but the USB connector head is thicker and longer than the Pioneer USB extender cable this replaced. Easy to mount recepticle under dash if you don't mind a screw hole, I mounted mine low in my 08 Sierra, so it won't be obvious if removed.